Personal Protective Equipment- Fall Protection Equipment

fall-prot-collage

There are two types of fall protection equipment’s commonly used in power generation, distribution and transmission work positioning and fall arrest equipment. Technical workers who aren’t qualified climbers are advised to use fall protection equipment if they are to work at higher locations 4+ feet) above the ground, such as poles, towers, and similar structures if other fall protection each rail.

Working positioning equipment:

These consist of any device such as body belt and pole strap used by anyone working on overhead line working on poles and towers. Technically, work positioning equipment keeps the user from falling off and allows their hands to be free to do the job.

Line climbers are always trained and show proficiency in climbing “qualified climbers.” A skilled climber there is no need to use fall protection equipment when ascending, descending or changing positions on the poles and tower. If the condition isn’t safe for the climber where the worker can lose their grip or footing fall protection equipment is highly recommended.

A condition that calls for the qualified climber need fall protection equipment are dangerous such as weather-high wind, ice or snow. There are certain configurations of the structure being climbing will necessity the use of fall arrest system. Find out more in this site : http://www.fallprotectionpros.com/

Fall arrest equipment:

This equipment’s come in many forms. If working on power generation, transmission, and distribution related tasks, you will automatically need to use a body harness fitted with a shock-absorbing lanyard. Workers lacking technical experienced in climbing works-unqualified climbers must use fall arrest equipment at all times while climbing.

The equipment should be properly rigged to ensure the worker doesn’t fall more than 6 feet or contact any lower levels.

When do you need fall arrest equipment?

  • When working in a bucket/basket, workers will wear fall protection equipment’s with the lanyard connected to the anchor point on the bucket. It’s imperative to do this as mechanical failures have resulted in buckets separating for the boom, and the work ends up falling. In some situation the line trucks get stuck by passing vehicles, launching the worker out of the bucket, and the fall could result in death. Click here !
  • When working 6 feet above the next lower level such as station transformers, the workers needs to wear fall arrest equipment with a lanyard attached to a secure and proper anchor point. In case the edges of the surface are protected by a guardrail or a safety net then the worker can climb without fall arrest equipment.

Design requirements:

There is a minimum design need that all fall protection equipment must have regarding material, strength, snap hooks, d-rings, attachment points, and other items. The design need is set by OSHA’s, and the minimum requirement must be included in purchase orders specification.

Inspection of fall equipment:

All the above fall protection equipment and work positioning equipment are required to be inspected each day before use and resist from using any if with a defect. It’s even safer to check the equipment before use and not only once daily.

Leave a Reply

Your email address will not be published. Required fields are marked *